AMPP Internal Corrosion for Pipelines - Level 2 - Senior-Internal-Corrosion-Technologist Exam Questions [2026]

QUESTION NO: 1
The cost of qualified Coating Inspection Is normally offset by:

A. Lower Supervision Costs B. Lower Coating Life Cycle Costs C. Lower Safety Enforcement Costs D. Lower Application Costs

Correct Answer: B

QUESTION NO: 2
Inspection and Test Plans are provided to:

A. So the contractor has a single document to reference B. To supersede the requirements of the product data sheets C. Outline the Inspection steps, sequencing and pass/fail criteria D. So the Inspector doesn't have to read the entire specification

Correct Answer: C

QUESTION NO: 3
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cute of

A. epoxies. B. inorganic zincs. C. urethanes. D. powder coatings.

Correct Answer: B

QUESTION NO: 4
Surface preparation methods for Non-ferrous metals are:

A. The same as for Ferrous metals B. Not required C. The same for all Non-Ferrous metals D. Specific for each type of Non-Ferrous metal

Correct Answer: D

QUESTION NO: 5
Coating Surveys are legally required:

A. On high pressure gas lines and fireproofed structures B. On water tanks and potable water pipelines C. On food and beverage vessels and can linings D. On commercial marine vessels and offshore platforms

Correct Answer: D

QUESTION NO: 6
When working with someone who Is very concerned about stability and maintaining adherence to the status- quo, the Inspector should try to:

A. Make sure they are the center of attention in all site meetings B. Challenge their value to the team and try to get them out of their comfort zone C. Implement Immediate changes to get them motivated D. Give them as much advance notice as possible about upcoming changes

Correct Answer: D

QUESTION NO: 7
A reinforced coating is

A. more resistant to movement, abrasion, and impact than a non-reinforced coating. B. equally resistant to movement and impact as a non-reinforced coating. C. less resistant to movement, abrasion, and impact than a non-reinforced coating. D. equally resistant to abrasion and impact as a non-reinforced coating.

Correct Answer: A

QUESTION NO: 8
Which is used to calibrate a pH meter?

A. Standard solvent solution B. Distilled water C. Deionized water D. standard buffer solution

Correct Answer: D

QUESTION NO: 9
You are a NACE Level 2 in-house inspector working in a shop. Your In-house UP requires you to perform a sleeve test to test for soluble sails; however the 3rd party NACE Level 3 inspector, representing the owner, has used a salt smart meter and has achieved a very different result and has rejected the pre cleaning.
Your FIRST preferred course of action is to:

A. Advise the other Inspector he is using an Incorrect method B. Redo the pre-cleaning based on the other Inspectors results C. Advise your QC Manager to change the UP to the use of the salt smart meter D. Review the specification with the other inspector to see what method was specified

Correct Answer: D

QUESTION NO: 10
Which standards are generally established by private-sector bodies and are available for use by any person or organization, private or government?

A. Mandatory B. Consensus C. Defector D. Voluntary

Correct Answer: B