BICSI Registered Communications Distribution Designer

QUESTION NO: 1
In an office area, a consultant needs to add the location of a fax machine to the plan. What is the approximated floor area that a fax machine occupies?

A. 1 sq m (10 sq ft) B. 1.5 sq m (16 sq ft) C. 2 sq m (20 sq ft) D. 0.2 sq m (2 sq ft) E. 0.5 sq m (5 sq ft)

Correct Answer: A

QUESTION NO: 2
As a guide, the recommended maximum AC current value on any bonding conductor should be less than ________ amperes.

A. 10 B. 20 C. 1 D. 5 E. 0.50

Correct Answer: C

QUESTION NO: 3
You have been selected to do the telecommunications design on a new, single story building. The architect requires the size and location of the telecommunications rooms so their building design can proceed. From the items listed below (all of which are required for the design), which one is the logical starting point in order to provide the architect with a size and location for the room?

A. Determine the types of equipment to be installed in the room B. Determine the power, HVAC, electrical, and security requirements for the room C. Determine where the entrance facility will be D. Determine future growth and other requirements E. Determine the number of , their locations, and telecommunications services needed

Correct Answer: E

QUESTION NO: 4
Which one of the following is part of the security metric to consider in selecting the appropriate labels for an administrative system?

A. Temperature rating B. Moisture content C. Adhesive type D. Smudge resistance E. Tamper resistance

Correct Answer: E

QUESTION NO: 5
Exhibit:

In this future marina layout, what would be the pre-cabling guideline to follow for the terminal A?

A. Place distribution cable onto the dock and terminate in a suitable cabinet or enclosure. Run
service drop to each boat slip. B. Provide one or two pair cables from the boat slips to a distribution terminal on the closest point of land. C. Pre-cable each boat slip during construction. D. For security, each run should be terminated in the patch panel/ cross-connect at the dockmaster or marina office.

Correct Answer: A

QUESTION NO: 6
If you have a 30 cm (12 in) wide data tray, what does ANSI/TIA 569-B recommend be the maximum pathway fill cross sectional area assuming a MAXIMUM pathway depth of 15 cm (6 in)?

A. 225 sq cm (36 sq in) B. 150 sq cm (24 sq in) C. 450 sq cm (72 sq in) D. 300 sq cm (48 sq in) E. 112.5 sq cm (18 sq in)

Correct Answer: A

QUESTION NO: 7
In the ceiling zone method of distribution, the usable floor area should be divided into zones each measuring:

A. 56 sq m (600 sq ft) to 84 sq m (904 sq ft) B. 56 sq m (600 sq ft) to 100 sq m (1,100 sq ft) C. 23 sq m (250 sq ft) to 84 sq m (904 sq ft) D. 9.3 sq m (100 sq ft) to 23 sq m (250 sq ft) E. 23 sq m (250 sq ft) to 56 sq m (600 sq ft)

Correct Answer: C

QUESTION NO: 8
An open office design is made up of three furniture clusters and contains a total of nine. How many multiuser telecommunications outlet assemblies (MUTOA) should be in the design?

A. 9 B. 1 C. 6 D. 3 E. 4

Correct Answer: D

QUESTION NO: 9
For design purposes, loudspeakers are rated for a measured sound pressure level (SPL) at:

A. 3 m (10 ft) from the loudspeaker with 1 watt of power input B. 1 m (3.3 ft) from the loudspeaker with 2 watts of power input C. 1 m (3.3 ft) from the loudspeaker with 1 watt of power input D. 3 m (10 ft) from the loudspeaker with 2 watts of power input

Correct Answer: C

QUESTION NO: 10
At a minimum, convenience receptacles in an ER or TR are to be located ________ AFF.

A. 150 mm (6 in) B. 450 mm (18 in) C. 300 mm (12 in) D. 375 mm (15 in)

Correct Answer: A

QUESTION NO: 11
The information technology system (ITS) designer should design conduits entering a building from ceiling height to terminate ________ below the finished ceiling.

A. 51 mm (2 in) B. 100 mm (4 in) C. 254 mm (10 in) D. 152 mm (6 in) E. 203 mm (8 in)

Correct Answer: B

QUESTION NO: 12
The information technology system (ITS) designer should design conduits entering a building from below grade point to extend ________ above finished floor (AFF).

A. 51 mm (2 in) B. 100 mm (4 in) C. 254 mm (10 in) D. 152 mm (6 in) E. 203 mm (8 in)

Correct Answer: B

Explanation: Only visible for Pass4Test members. You can sign-up / login (it's free).

BICSI Registered Communications Distribution Designer - RCDD Exam Questions