Fortinet NSE 6 - OT Security 7.6 Architect - NSE6_OTS_AR-7.6 Exam Questions

QUESTION NO: 1
Refer to the exhibit. A partial Application Sensor profile is shown.

When you apply this profile in a firewall policy, which two statements are correct? (Choose two answers)

QUESTION NO: 2
In your OT environment, you want to detect the devices passively. Which two methods must you implement? (Choose two.)

QUESTION NO: 3
Which three common breach points can you find in a typical OT environment? (Choose three.)

QUESTION NO: 4
Refer to the exhibit. The IPS profile is added on all of the security policies on FortiGate. For an OT network, which statement of the IPS profile is true?

QUESTION NO: 5
Refer to the exhibits.


A partial OT network and firewall policies configuration are shown.
You added authentication in the firewall policy from Engineering Workstation to RTU to improve the security. When verifying your configuration, you notice that you can still access RTU from Engineering Workstation without an authentication prompt.
What must you do to enforce authentication?

QUESTION NO: 6
Refer to the exhibit, which shows a non-protected OT environment.

An administrator needs to implement proper protection on the OT network. Which three steps should an administrator take to protect the OT network? (Choose three.)

QUESTION NO: 7
You want to automate some tasks in your OT network. Which three configurations are directly available in a new basic event handler on FortiAnalyzer? (Choose three.)

QUESTION NO: 8
Refer to the exhibits. The Playbook Monitor dashboard and the analysis of the corresponding incident analysis are shown.
You created the playbook with the objective of automatically attaching the report to the incident that was created.
Which two statements are correct? (Choose two.)

QUESTION NO: 9
How can you achieve remote access and internel availability in an OT network?

QUESTION NO: 10
Refer to the exhibit.

A partial Application Sensor configuration is shown.
You want to monitor the OT protocols in your network and have applied the OT_monitoring profile in the firewall policy. After generating OT traffic, you do not see any OT-related logs in the Application Control section.
Which action must you perform?

QUESTION NO: 11
A supervisor is configuring a software switch on a FortiGate device. What must the supervisor configure on FortiGate to control the traffic between member interfaces on the software switch, using firewall policies?

QUESTION NO: 12
Refer to the exhibit. A Virtual Patching profile is shown.

You have recently updated your SCADAsystem and would like to apply the SCADA virtual patching profile.
Which two statements about this profile are correct? (Choose two answers)

QUESTION NO: 13
Refer to the exhibit.

A FortiAnalyzer report is shown.
You must extract information about your OT network from the report.
Which two statements are correct? (Choose two.)