Juniper Service Provider Design Specialist (JNCDS-SP)

QUESTION NO: 1
Your customer's enterprise is adding geographically dispersed branch offices and requires new WAN connections. The primary design consideration for this expansion is low cost.
Which type of WAN connection satisfies the customer's requirement in this scenario?

A. Internet connection with IPsec B. transparent Layer 2 service C. MPLS Layer 3 VPN D. leased line dedicated circuit

Correct Answer: B

QUESTION NO: 2
Your customer requires virtual machine mobility between two data centers, and they are pursuing a managed service.
Which solution would satisfy the customer's requirement?

A. an EVPN service provided over IP B. an L3VPN service C. a routed service D. an IPsec VPN service between CE routers

Correct Answer: B

QUESTION NO: 3
Which two statements are correct about Junos Space Connectivity Services Director? (Choose two)

A. It is used to design and simulate MPLS-TE and LSP routing. B. It is used to design, provision, and monitor Label Discovery Protocol (LDP) and Border Gateway Protocol (BGP) services on devices C. It is used to design, provision, and deploy MPLS-dynamic, RSVP-signaled LSP, and static LSP services on devices. D. It is used to provide zero touch provisioning (ZTP), which simplifies the deployment of networks by providing policy-driven plug-and-play provisioning and network bring-up operations.

Correct Answer: C,D

QUESTION NO: 4
You are asked to provide a design proposal for a service provider's core network. The network consists of both IPv4 and IPv6 addresses and must scale up to 50 core routing devices.
In this scenario, which statement is correct regarding the IGP design?

A. You can use OSPFv2 for IPv4 and OSPFv3 for IPv6 at the same time. B. You must use OSPFv3 to support both address families. C. You can use OSPFv2 to support both address families. D. You must use IS-4S to support both address families.

Correct Answer: D

QUESTION NO: 5
A customer reports that their RSVP LSP deployment faces scaling challenges as their network grows. You are asked to propose ways that the network can be optimized.
What are two ways that Paragon Pathfinder (formerly known as NorthStar) helps achieve this optimization? (Choose two.)

A. faster detection of LSP failure B. reduction in LSPs due to optimal path selection C. creation of LSPs across different IGP areas D. offloading control plane state to a central controller

Correct Answer: A,D

QUESTION NO: 6
Which statement is correct about learning remote host MAC addresses when your DCI is based on EVPN?

A. Static MAC configuration on the provider edge (PE) device is perform B. Data plane MAC learning by the provider edge (PE) device is performed. C. No MAC learning by the provider edge (PE) device is performed D. Control plane MAC learning by the provider edge (PE) device

Correct Answer: B

QUESTION NO: 7
You are designing the physical redundancy for a service provider network and are checking for potential risks due to fate sharing.
Which two sources of fate sharing should you examine in this scenario? (Choose two.)

A. MPLS LSP B. building location C. hardware vendor D. fiber conduit

Correct Answer: A,B

Juniper Service Provider Design Specialist (JNCDS-SP) - JN0-1362 Exam Questions