HP Migrating &Troubleshooting Enterprise Networks

QUESTION NO: 1
RRPP statistics for an HP A-Series switch indicate that Hellos are being received on the secondary port but do not indicate that Hellos are being sent on the primary port. What most likely caused this?

A. The switch is in Edge node mode. B. A link-down message has been sent by the Master node. C. The primary port is down. D. The RRPP ring is in a fail state. E. The switch is in Transit node mode.

Correct Answer: E

QUESTION NO: 2
Click the Exhibit button.

A customer has a Cisco-based network, and you are replacing the distribution layer switches with HP E-Series switches. The customer wants you to perform the migration with as little downtime as possible, and you plan to connect the E-Series switches temporarily in parallel with the current distribution switches, as shown in the exhibit. As part of the migration, the customer wants you also to migrate the remaining Cisco switches to open-standard protocols rather than the proprietary Cisco ones, which the exhibit shows that these switches currently use. Which Cisco proprietary protocol should you wait to migrate until after you remove the Cisco distribution switches in order to avoid connectivity issues?

A. Cisco Discovery Protocol (CDP) to Link Layer Discovery Protocol (LLDP) B. VLAN Trunking Protocol (VTP) to static VLANs C. Extended Interior Gateway Routing Protocol (EIGRP) to Open Shortest Path First (OSPF) D. Rapid Per-VLAN Spanning Tree Plus (Rapid PVST+) to Multiple Spanning Tree Protocol (MSTP)

Correct Answer: D

QUESTION NO: 3
Click the Exhibit button.

You are replacing a Cisco BGP router with an HP A-Series BGP router. Examine the router's configurations. Which statements accurately describe the routers' configurations? (Select three.)

A. Both BGP routers announce network 215.34.10.0/22. B. Both BGP routers announce a static route to its BGP neighbor. C. The A-Series router's prefix list is misconfigured. D. The HP A-Series router will not implement the same BGP functions as the Cisco router. E. Neither BGP routers can announce a redistributed static route because no metrics are set. F. Both configurations are identical in function.

Correct Answer: A,B,F

QUESTION NO: 4
Click the Exhibit button.

You are replacing your Cisco distribution layer switches with HP A-Series switches. The Cisco switches have a VLAN map applied to VLAN 21 (subnet 10.2.21.0/24). The following is a configuration for this VLAN map:

The exhibits display possible configurations for the HP A-Series switch. Which configuration controls traffic that arrives on VLAN 21 in the same way that the current Cisco switches do?

A. Exhibit 3 B. Exhibit 2 C. Exhibit 4 D. Exhibit 1

Correct Answer: B

QUESTION NO: 5
You are in the process of replacing Cisco switches at the distribution layer with HP A-Series switches. You have connected the A-Series switches in parallel with the existing Cisco switches at the distribution level, edge, and core. The HP A-Series switches are configured for Intelligent Resilient Framework (IRF) and the VLAN interfaces have been assigned an unused IP address for the router address. You now want the A-Series switches to assume routing responsibilities for one of your network four VLANs. Youaddress for the router address. You now want the A-Series switches to assume routing responsibilities for one of your network? four VLANs. You alter the DHCP scope to reflect the new gateway IP address. What should you verify before beginning this step?

A. that HP A-Series switches have all necessary routes to non-directly connected networks B. that the HP A-Series switches are the root of the Spanning Tree in the VLAN that you are migrating C. that you have disabled the interface for the VLAN that you are migrating on the Cisco distribution switches D. that Cisco distribution switches can learn a route for the VLAN that you are migrating after the migration

Correct Answer: A

QUESTION NO: 6
Click the Exhibit button.

You are replacing a Cisco BGP router with an HP A-Series BGP router. Configurations of the Cisco and HP devices are shown in the exhibit.Which statements are true about the routers' configurations? (Select three.)

A. Both the Cisco and HP router configurations are identical in function. B. The routers are implementing a typical configuration for a BGP Multihome router. C. The routers are implementing a typical configuration for a BGP router of a Transit AS. D. Both BGP router filter all networks sent to BGP neighbor 222.222.10.1 except the IP prefix 200.1.0.0/23. E. The HP router will not provide identical functionality to the Cisco router. F. The HP A-Series router sends all networks to the BGP neighbor 222.222.10.1 except the IP prefix 200.1.0.0/23.

Correct Answer: A,B,D

HP Migrating &Troubleshooting Enterprise Networks - HP0-Y37 Exam Questions