HP-UX System Administration - HP0-091 Exam Questions [2026]

QUESTION NO: 1
Which command lists the registered software depots on the local HP-UX server?

A. swconfig -L depot B. swlist -list bundle C. swlist -l depot D. swinstall -l depot

Correct Answer: C

QUESTION NO: 2
What is a network socket?

A. the connector for a twisted-pair network cable B. a virtual connection between two NICs C. a data buffer used during network exchanges D. an encrypted network communication path

Correct Answer: B

QUESTION NO: 3
Which file is used to configure networking parameters such as hostname, IP address, and subnet mask?

A. /etc/rc.config.d/network B. /etc/rc.config.d/ipconf C. /etc/rc.config.d/lanconf D. /etc/rc.config.d/netconf E. /etc/rc.config.d/ifconf

Correct Answer: D

QUESTION NO: 4
The commands, scp and sftp, perform what additional benefit over standard ARPA/Berkley equivalents?

A. spawns multiple daemons B. secure communications C. lower overhead D. increased speed

Correct Answer: B

QUESTION NO: 5
Which statement is true regarding a device file's major number?

A. It is used to allocate buffer space. B. It sets the kernel response timeout in tics. C. It is determined by its hardware address. D. It determines the device's interrupt priority. E. It points to the associated kernel driver.

Correct Answer: E

QUESTION NO: 6
To display the available routes and their status, which command would you use?

A. route -s B. routestat C. netstat -rn D. sysstat

Correct Answer: C

QUESTION NO: 7
Which command is used to trim the length of an active file called log-file? Select TWO.

A. >log-file B. rm log-file ; touch log-file C. freset log-file D. trim log-file E. cat /dev/null > log-file

Correct Answer: A,E

QUESTION NO: 8
How do you set up a device swap area and ensure it is active at each system startup?

A. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/vfstab file. B. Start device swapping using theswapon command on an existing file system mount point. C. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/sbtab file. D. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/fstab file.

Correct Answer: D

QUESTION NO: 9
Which system file is used to store information about networks that are connected to the system?

A. /etc/nettab B. /etc/nic C. /etc/netconfig D. /etc/networks

Correct Answer: C

QUESTION NO: 10
What does a hard link between two files do?

A. allows data to span 2 files B. ensures that 2 files get deleted together C. allows multiple file names to reference the same data on disk D. allows 2 users to own the same file

Correct Answer: C