Huawei HCIA-Datacom V1.0 - H12-811_V1.0-ENU Exam Questions
QUESTION NO: 1
Which method does VRP not support to configure the router?
Which method does VRP not support to configure the router?
Correct Answer: A
QUESTION NO: 2
LACP protocol priority as shown in the figure, switch A and switch B adopt LACP mode link aggregation, and all interfaces are added to the link aggregation group, and the maximum number of active ports is set to 3, which port of switch A is not active port?
LACP protocol priority as shown in the figure, switch A and switch B adopt LACP mode link aggregation, and all interfaces are added to the link aggregation group, and the maximum number of active ports is set to 3, which port of switch A is not active port?
Correct Answer: C
QUESTION NO: 3
The Layer 2 switch belongs to the data link layer device, which can identify the mac address information in the data frame, forward the data according to the mac address, and record these mac addresses and corresponding port information in its own mac address table.
The Layer 2 switch belongs to the data link layer device, which can identify the mac address information in the data frame, forward the data according to the mac address, and record these mac addresses and corresponding port information in its own mac address table.
Correct Answer: A
QUESTION NO: 4
The network administrator configures the Huawei router RTA as shown in the figure. If a user needs to be authenticated in the authentication domain "huawei", which of the following descriptions is correct?
[RTA] aaa
[RTA-aaa] domain huawei
[RTA-aaa-domain huawei] authentication-scheme au1
[RTA-aaa domain-huawei] authentication-scheme au2
The network administrator configures the Huawei router RTA as shown in the figure. If a user needs to be authenticated in the authentication domain "huawei", which of the following descriptions is correct?
[RTA] aaa
[RTA-aaa] domain huawei
[RTA-aaa-domain huawei] authentication-scheme au1
[RTA-aaa domain-huawei] authentication-scheme au2
Correct Answer: A
QUESTION NO: 5
The Tos field is used for QoS marking in the IP message, and the first 6 bits of the Tos field are used to mark the DSCP.
The Tos field is used for QoS marking in the IP message, and the first 6 bits of the Tos field are used to mark the DSCP.
Correct Answer: A
QUESTION NO: 6
On a broadcast network, both DR and BDR use the multicast address 224.0.0.6 to receive link state update messages.
On a broadcast network, both DR and BDR use the multicast address 224.0.0.6 to receive link state update messages.
Correct Answer: A
QUESTION NO: 7
Which of the following packets are used for IPv6 stateless address auto-configuration? (Multiple choice)
Which of the following packets are used for IPv6 stateless address auto-configuration? (Multiple choice)
Correct Answer: B,C
QUESTION NO: 8
When an IPv6 interface receives a data packet with a value of 1 in the Hop Limit field, it will not forward the data packet.
When an IPv6 interface receives a data packet with a value of 1 in the Hop Limit field, it will not forward the data packet.
Correct Answer: A
QUESTION NO: 9
FIT AP can work independently without AC.
FIT AP can work independently without AC.
Correct Answer: B
