F5 BIG-IP Administration Install, Initial Configuration, and Upgrade - F5CAB1 Exam Questions

QUESTION NO: 1
The device is currently on v15.1.2.1.
The BIG-IP Administrator needs to boot the device back to v13.1.0.6 to gather data for troubleshooting.
The system shows:
Sys::Software Status
Volume Product Version Build Active Status Allowed
HD1.1 BIG-IP 15.1.2.1 0.0.10 yes complete yes
HD1.2 BIG-IP 13.1.0.6 0.0.3 no complete yes
Which is the correct command-line sequence to boot the device to version 13.1.0.6?

QUESTION NO: 2
What is the default IP address of a newly installed BIG-IP system?

QUESTION NO: 3
A BIG-IP Administrator needs to install a HotFix on a standalone BIG-IP device.
The device currently has HD1.1 as the Active Boot Location.
The administrator has already reactivated the license and created a UCS archive.
In which sequence should the administrator perform the remaining steps?

QUESTION NO: 4
What is the first step in the initial setup of a BIG-IP device?

QUESTION NO: 5
What is the purpose of a Virtual Server in BIG-IP?

QUESTION NO: 6
What should you do before performing a software upgrade on BIG-IP?

QUESTION NO: 7
The BIG-IP Administrator wants to manage the newly built F5 system through an in-band Self-IP.
The administrator has configured a VLAN and Self-IP and can ping the IP from their workstation, but cannot access the system via SSH or HTTPS.
What port lockdown settings should the BIG-IP Administrator use to allow management access on the Self-IP? (Choose two.)

QUESTION NO: 8
An F5 VE has been deployed into a VMware environment via an OVF file.
An administrator wants to configure the management IP address so the VE can be accessed for further setup.
Which two are valid methods for configuring the management-ip address? (Choose two.)