EMC Dell PowerEdge MX Modular Deploy 2023 - D-PEMX-DY-23 Exam Questions [2026]

QUESTION NO: 1
A customer would like to periodically change the iDRAC root password on all the servers in their MCM Group.
What feature in OME-M should they use?

A. Quick Deploy B. Resource Pools C. SupportAssist D. Chassis Deployment Wizard

Correct Answer: A

QUESTION NO: 2
An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI.
What is the likely cause of this issue?

A. OS and iDRAC are configured on different networks B. OS to iDRAC pass-through feature is not enabled in the iDRAC C. Installed OS is not supported D. iDRAC Express license is installed

Correct Answer: B

QUESTION NO: 3
Where is a valid storage location for extracting the full MX7000 chassis logs package?

A. CIFS B. CSV C. FTP D. VMFS

Correct Answer: A

QUESTION NO: 4
Which uplink configuration combination of the Top of the Rack Switch and the MX7000 Management Module is supported?

A. 100 Mbps (Auto negotiation OFF) and Auto negotiation OFF B. 100 Mbps (Auto negotiation OFF) and Auto negotiation ON C. 100 Mbps (Auto negotiation ON) and Auto negotiation OFF

Correct Answer: A

QUESTION NO: 5
A technician is doing an initial MX7000 setup and wants to use KVM to configure the MM. KVM is not working.
What are the two causes of this issue?
(Select 2)

A. Mouse is not connected. B. MM is going through a reset. C. DP-to-DVI and DP-to-HDMI adapters are not supported. D. The resolution set on MM is too high.

Correct Answer: B,C

QUESTION NO: 6
Where are the diagnostic LEDs located on a PowerEdge MX750c compute sled?

A. Middle of the system board with the top of the cover removed B. Front of the sled after removing the bottom two drives C. Front of the sled after removing the top two drives D. Located on the back of the sled

Correct Answer: B

QUESTION NO: 7
A customer has an MCM group consisting of four MX7000 chassis. They need to take the lead chassis down to perform maintenance.
How can the customer ensure that another chassis takes over the lead role in the MCM Group?

A. The MCM group will elect a new lead chassis. B. Promote the backup lead chassis as the new lead chassis. C. The backup chassis will take the lead automatically. D. Promote the lead chassis to a passive chassis.

Correct Answer: B

QUESTION NO: 8
What is a characteristic of MX7000 networking in Scalable Fabric Mode?

A. All switch interfaces are assigned to VLAN 1 by default and are in the same Layer 2 bridge domain. B. Layer 2 bridging is disabled be default and interfaces must join a bridge domain (VLAN) before being to forward frames. C. Available on MX9116n FSE and MX7116n FEM but not on the MX5108n. D. Enabled by default, all switch-specific OS10EE capabilities are available.

Correct Answer: C

QUESTION NO: 9
Which three components store an MX7000 chassis service tag and MAC address configuration?
(Select 3)

A. Fabric Switching Engine B. Management Module C. Chassis Luggage Tag D. LCD Panel E. Right Control Panel

Correct Answer: B,D,E