API Source Inspector Electrical Equipment - API-SIEE Exam Questions [2026]

QUESTION NO: 1
Which of the following is listed as a typical transformer inspection point in the guide?

A. Ventilation fan blade pitch adjustment B. Verification of PCB content labeling C. Impeller alignment D. Rotor bar balance check

Correct Answer: B

QUESTION NO: 2
What is the process that aims to find potential defects in a product before it is released for delivery?

A. Inspection B. Quality Control C. Quality Assurance D. Examination

Correct Answer: A

Explanation: Only visible for Pass4Test members. You can sign-up / login (it's free).

QUESTION NO: 3
What is an inspection waiver?

A. Permission to proceed with manufacturing or fabrication pending resolution of a nonconformance report because of a critical schedule B. Permission to proceed with manufacturing or fabrication before a nonconformance release has been issued C. Permission to proceed with production or shipment without having a purchaser inspection representative present D. Permission to proceed with production or shipment without the source inspector present at a hold point

Correct Answer: D

Explanation: Only visible for Pass4Test members. You can sign-up / login (it's free).

QUESTION NO: 4
Which of the following is a typical topic for the pre-inspection meeting prior to the start of fabrication?

A. Future plant expansion strategy B. End-user operating philosophy only C. Employee annual leave planning D. Quality requirements such as ITP, NCRs, and inspection frequency

Correct Answer: D

QUESTION NO: 5
Which enclosure type is defined in the guide as a construction where free exchange of air is prevented between the inside and outside of the motor?

A. Open drip proof B. TEFC C. WP-II D. Purged pressurized

Correct Answer: B

QUESTION NO: 6
What would the equipment pictured below be used for?

A. Verification of proper spacing between motor and gearbox B. Precise measurement of machined equipment requiring close tolerances C. Calibration of precision measuring equipment D. Precise measurement of shaft alignment

Correct Answer: C

Explanation: Only visible for Pass4Test members. You can sign-up / login (it's free).

QUESTION NO: 7
Why should the dates for source inspection scheduled work process events such as the pre-inspection meeting, key inspection events and anticipated shipping date be identified in advance?

A. To ensure that all dates will meet the project schedule and quality requirements B. To allow coordination with other project members involved in the activity C. To provide a sound basis for inspection and test planning for each shop D. To be able to assign inspectors to the shops in order not to conflict with other projects

Correct Answer: B

Explanation: Only visible for Pass4Test members. You can sign-up / login (it's free).