Cisco Implementing Cisco Unified Wireless Mobility Services (IUWMS v2.0)

QUESTION NO: 1
With which interface or interfaces can a MAP reach a Cisco WLC v7.0 for communication?

A. through wired only B. through 2.4-GHz radio only C. through 2.4- or 5-GHz radio only D. through wired or 2.4- or 5-GHz radio E. through 5-GHz radio only

Correct Answer: D

QUESTION NO: 2
Which problem develops when antennas are located too close to or too high from the device that is being tracked for location services?

A. There is an inconsistent rate of SNR change per unit of distance. B. RSSI becomes too low. C. There is an inconsistent rate of RSSI change per unit of distance. D. PER becomes too great. E. SNR becomes too great.

Correct Answer: C

QUESTION NO: 3
The Cisco 3300 Series MSE v7.0 has been manually configured for passwords, IP address, gateway, and hostname. The Cisco WCS v7.0 can ping Cisco MSE but is not able to add the MSE context-aware services. What is the most likely issue?

A. Network services were not started on Cisco MSE. B. NTP is not configured on Cisco MSE. C. Context-aware services were not licensed on MS D. Context-aware services were not installed on Cisco MSE. E. MSE services were not started on Cisco MSE.

Correct Answer: E

QUESTION NO: 4
Which statement correctly describes an event that would trigger a Cisco WCS v7.0 location-tracking event notification based on a Missing condition?

A. Device is missing for a defined period of time from the Cisco WCS map. B. Device is missing from a Cisco WCS at a defined distance from a location marker on the floor map. C. Device is missing from a location that is defined by Cisco WCS map rails. D. Device is missing from inside a Cisco WCS defined location map perimeter.

Correct Answer: A

QUESTION NO: 5
A pair of WLCs have been configured in a mobility group. The WLC reports that the control path is up, but the data path remains down. What two settings should the engineer check to remedy the issue?

A. The virtual interface IP is the same on both controllers. B. The controllers have the same location name C. UDP port 97 is open/allowed between the two controllers. D. The service port IP is the same on both controllers. E. UDP ports 16666 and 16667 are open/allowed between the two controllers. F. The controllers do not have the same RF network name

Correct Answer: E

QUESTION NO: 6
An engineer is having problems tracking pallets with the MSE in a high-ceiling warehouse. What two technologies should be implemented? (Choose two.)

A. Monitor Mode Aps B. Local Mode Aps C. ToA Sensors D. AeroScout Tag Engine E. TDoA Sensors F. Cisco Tag Engine

Correct Answer: D,E

QUESTION NO: 7
Cisco Mesh is designed to be effective at a maximum of how many wireless hops?

A. 16 B. 8 C. 2 D. 4

Correct Answer: B

QUESTION NO: 8
When connected in MAP mode, what is the reason for an AP to scan on its connectivity radio every 5 seconds?

A. discover rogues B. monitor air conditions C. discover nearby co-channel for RRM action D. catalogue parent successors

Correct Answer: D

QUESTION NO: 9
Which two statements describe the software v7.0 implementation of LAG on a Cisco controller? (Choose two.)

A. It is supported on the Cisco FlexConnect 7500 controller. B. Fewer IP addresses are required. C. The switch channel group negotiates with LAGP. D. The switch channel group negotiates with PaGP. E. The LAG port becomes port 29. F. The LAG port becomes port 15. G. It is supported on Cisco WLC 2500.

Correct Answer: B,C

QUESTION NO: 10
Which location-tracking solution requires clock synchronization on receivers only?

A. modified cell of origin B. RSS trilateration C. cell of origin D. ToD E. AoA F. TDoA

Correct Answer: F

Cisco Implementing Cisco Unified Wireless Mobility Services (IUWMS v2.0) - 642-747 Exam Questions