Avaya Ethernet Routing Switch Implementation - 6101.1 Exam Questions [2026]

QUESTION NO: 1
The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network.
HMD primary benefits of this design goal? (Choose two)

A. This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS) and 10 gigabit Ethernet. B. in the event of a failure, no loss of connectivity or application availability will be experienced by the end user C. The ability to provide hitless software upgrades for the core of the network. D. The architecture provides high performance Layer 3 switching, resiliency, security, and services.

Correct Answer: B,C

QUESTION NO: 2
Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a full stack of eight switches?

A. 720 Gbps B. 640 Gbps C. 1.15 Tbps D. 400 Gbps

Correct Answer: B

QUESTION NO: 3
Consider the following deployment requirements
Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable
Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber.
Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?

A. One 8348GTx One 8348Tx-PWR One 8393SF B. One 8348GTx One 8348Tx-PWF One 8308 XL One 8393SF C. Two 8348GTx-PWF One 8308XX One 8393SF D. Two 8348TX-PWR One 8393SF

Correct Answer: A

QUESTION NO: 4
For a Converged Campus network, which configuration change is recommended for the default VLAN (VLAN 1)?

A. Remove the default VLAN from active ports. B. Configure QoS on the default VLAN to support voice traffic. C. Remove spanning tree from the default VLAN D. Assign an IP address to the default VLAN for switch management

Correct Answer: D

QUESTION NO: 5
One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced.
The auto unit replacement (AUR) is enabled but the stack is not functioning properly.
What is the problem?

A. The stack has two switches with Force Stack disabled. B. The switches in the stack are not identical C. the stack power was left on during the switch replacement. D. The switches in the stack are not running the same release of software

Correct Answer: C

QUESTION NO: 6
Click the exhibit button

SLPP has just been enabled on both core switches.
Based on the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) B600 shown in the exhibit, what is the configuration error on the edge switch?

A. The edge VUXNs has not been configured. B. The edge switch spanning-trcc has not been configured. C. The edge switch access port rate limiting has not been configured. D. The edge MLT has not been configured correctly.

Correct Answer: B

QUESTION NO: 7
With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features.
Which two statements ant true about the Advanced Routing License process and supported features for the ERS 8300? (Choose two.)

A. To protect against system flash failure, the ERS 8300 allows a primary, secondary, and tertiary path for the license file. B. To protect against security breaches, the ERS 8300 allows only a primary path for the license file C. the Advanced Routing License supports SMLT, VRRP, OSPF, PIM-SM. and SLPP D. the Advanced Routing License supports QoS, SMLT, VRRP and OSPF

Correct Answer: A,C