Cisco Designing Cisco Wireless Networks - 300-110 Exam Questions

QUESTION NO: 1
Refer to the exhibit. A wireless engineer is using the Ekahau Site Survey tool to conduct a post-deployment survey. The engineer analyzes the pictured output to determine if SNR meets the voice requirements. How is the voice support based on the output?
Exhibit - Q15: Ekahau SNR Heatmap - Post-Deployment Survey Output

QUESTION NO: 2
An engineer is performing an AP-on-a-stick survey and finds that the 5 GHz channel overlap is too high when an appropriate number of APs are used for the density requirements. Which two actions during the survey reduce channel overlap? (Choose two.)

QUESTION NO: 3
A network engineer is designing a new wireless network for a campus. The network must include optimized performance, avoid interference, availability in high-density areas, and roaming. Which two approaches must be taken? (Choose two.)

QUESTION NO: 4
A customer is building a new warehouse facility that has only its foundation and perimeter walls built. The building will be complete in the next eight months. The customer needs a detailed bill of materials and costs for a wireless network that must support RF scanners throughout the warehouse. How should the survey be performed?

QUESTION NO: 5
A wireless engineer is getting ready to perform a predictive site survey. The new network needs to support data and voice over wireless. Which two Cisco recommendations should be considered for the design?
(Choose two.)

QUESTION NO: 6
A university wants to deploy a high density of APs in an area where a high number of users congregate.
Which functionality allows the university to optimize the RF settings for APs that operate in different environments or coverage zones?

QUESTION NO: 7
A wireless network consists of two IOS XE controllers installed in a data center, 9100 series APs, and a corporate and a guest WLAN. The customer must have a high availability pair of two Cisco WLCs for the client SSO. Which two design approaches must the engineer take to meet the requirement? (Choose two.)

QUESTION NO: 8
A customer wants to provide wireless coverage in a parking lot outside of a building. An engineer determines that three APs are required. The APs can be mounted on the light poles in the parking lot because there are cable routes already in place for these locations. The closest wiring closet is approximately 200 meters away.
Which setup powers and connects the APs back to the customer network?

QUESTION NO: 9
Which strategies must the engineer use for the antenna deployment model in a warehouse?

QUESTION NO: 10
An engineer is upgrading the legacy APs to 802.11ac Wave 2 capable APs. The existing gigabit uplinked switches provide 802.3at. Which switch limitation is a concern?