Network Appliance NetApp Certified Implementation Engineer - SAN, 7-Mode

QUESTION NO: 1
When building your implementation plan, providing dual power for all systems is critical. Which three actions should be mandated? (Choose three.)

A. Power feeds should be connected to separate outlets connected to two separate PDUs. B. Dual power feeds should be run to all equipment. C. Power feeds should be connected to separate circuits on the same data center PDU. D. Power feeds should be connected to the closest available outlet inside the cabinet. E. Dual power supplies should be placed in all equipment.

Correct Answer: A,B,E

QUESTION NO: 2
A Solaris administrator just noticed that a host has lost connectivity to the company SAN. Which file should the administrator check for SAN connectivity errors?

A. /etc/syslog B. /var/adm/messages C. /opt/errorlog.log D. /etc/sysevent

Correct Answer: B

QUESTION NO: 3
What are two functions of iSCSI access lists? (Choose two.)

A. limit the number of network interfaces advertised by the storage system B. control the network interfaces on the storage system that an initiator can access C. define MPIO behavior D. define authentication parameters(CHAP)

Correct Answer: A,B

QUESTION NO: 4
NetApp supports multiple FC paths from the host to the NetApp storage controllers. In addition to using multiple FC switches, which other NetApp supported components should you use for this type of configuration?

A. HBA with driver and firmware, multiple storage controllers with multiple target ports each B. HBA with driver and firmware, multipathing host software, multiple storage controllers with multiple initiator ports each C. multipathing host software, multiple storage controllers with multiple target ports each D. HBA with driver and firmware, multipathing host software, multiple storage controllers with multiple target ports each

Correct Answer: D

QUESTION NO: 5
What is the appropriate method for testing high availability controller failover?

A. shut down a controller B. issue the takeover command from a controller C. issue the giveback command from a controller D. pull a power cord from a power supply on a controller

Correct Answer: B

QUESTION NO: 6
A customer has a four-node SUN cluster configuration. Each node has two, dual-ported HBAs. What is the minimum number of igroups that need to be created to map a LUN to the cluster?

A. 1 B. 8 C. 2 D. 4

Correct Answer: A

QUESTION NO: 7
What is the default Ethernet packet size (or MTU - Maximum Transmission Unit) for Ethernet ports on Ethernet switches?

A. 1500 bytes B. 12000 bytes C. 2112 bytes D. 9000 bytes

Correct Answer: A

QUESTION NO: 8
Which option needs to be set on a LUN to guarantee that it cannot be affected by other LUNs in the volume?

A. LUN Reservation Enabled B. Volume Space Reserved C. LUN Reservation Disabled D. Volume Guarantee

Correct Answer: A

QUESTION NO: 9
What should you do to verify FC connectivity between the host and the FC switch?

A. check the FC switch for the WWPN of the host HBA B. check the FC switch for the port type of the host port C. check the FC switch for light on the FC port D. ping the FC switch Ethernet port from the host

Correct Answer: A

Network Appliance NetApp Certified Implementation Engineer - SAN, 7-Mode - NS0-502 Exam Questions